Let's use this baseball bat video for some good. Some of us newer folks could benefit from the experiance on this board. What are "proper" turning speeds?
Keeping in mind that all of us have different comfort levels, chime in on the following;
Pens
Roughing Spindles (square)
Roughing Spindles (round)
Roughing bowls (square)
Roughing bowls (round)
Hollowing - chisel
Hollowing - Fostner bit
Finish cuts Spindles
Finish cuts bowls (square)
Sanding both
Finish application...on the lathe of course
This should be a good one!!
Keeping in mind that all of us have different comfort levels, chime in on the following;
Pens
Roughing Spindles (square)
Roughing Spindles (round)
Roughing bowls (square)
Roughing bowls (round)
Hollowing - chisel
Hollowing - Fostner bit
Finish cuts Spindles
Finish cuts bowls (square)
Sanding both
Finish application...on the lathe of course
This should be a good one!!