Jim Suzda
Member
- Messages
- 26
- Location
- Rudolph, WI
I’m looking for some ideas and pictures on how to make a “sled” or a jig to hold drawer sides or box sides when using a 45 degree lock miter bit in my shaper. (I suppose the same jig could be used on a router table.)
What I’m looking for ideas for a jig, or a fixture, that will hold the stock pieces for both the horizontal and the vertical pass past the bit. When I try to just hold the pieces against a miter gauge or the tall fence there is always a little “wiggle” that will ruin the profile.
Has anyone made their own jig to do this that you could share with me and others?
What I’m looking for ideas for a jig, or a fixture, that will hold the stock pieces for both the horizontal and the vertical pass past the bit. When I try to just hold the pieces against a miter gauge or the tall fence there is always a little “wiggle” that will ruin the profile.
Has anyone made their own jig to do this that you could share with me and others?