asking me to draw something, hahaha.......youd have better pictures from a 4 y/o with crayons......but I drew this before I left work, measurements arent in it, figure total height around 42 inches, total width, approx 24-26 inches
Legs will extend 4-6 inches below bottom of walls.
Face frame in front will be biscuited on, then 2 or 4 doors.
Shelves dadoed in bottom of side wall, and middle. Oak ply for shelves and walls. Id screw on a 1/4 " oak ply for the back.
If I knew basic furniture construction, I wouldnt be asking.
If I was smart, Id get someone here to build it for me, but then Id have no fun messing up everything.
heres a very, very rough sketch of whats in my head.(dont know if it will help, but at least I proved how much of a beginner I am, and not too ashamed of it, cough, cough)
Now that I looked, it doesnt help that much.
I was thinking I could use something like a half lap joint between the ply and legs, cut out 3/4 of an inch on the inside of the legs, attach with glue and screws, but I dont know how oak ply would cut for a half lap joint, never tried.(I have time to think about it, I have most of the wood, but Im going to experiment with Mahogany and Cumaru, making a chair out of each, and I promised alot of chairs before the summer ends, going to make around 60 bucks a chair, not what Im doing it for, but I get egged on by my wife if Im going to build it for someone else, they want to pay, they are getting a tremendous bargain, I should just take the profit and buy myself more tools)